TSmith 0 Posted May 12, 2023 Hi, I'm very new to this. Have cut a handful of jobs. I'm 50% threw a job rite now. Cut the first half fine. Turned the machine off. Came back a little later, loaded the other half of the job. I set the iron and my cutter read the first registration mark and then couldn't find the 2nd registration mark and acted lost. It is now permanently lost lol. I've calibrated it several times and still no luck. Share this post Link to post Share on other sites
Knothead 1 Posted May 13, 2023 I have a Laserpoint 3, I will tell you it is very very picky about the registration marks, be sure everything is lined up and good and square when you load it. Share this post Link to post Share on other sites
