mlgoodrich09 2 Posted April 30, 2021 how do i load a single sheet in my mk2 cutter instead of a roll? also how i do put heat transfer on to a tshirt Share this post Link to post Share on other sites
haumana 1,220 Posted April 30, 2021 If you're trying to cut HTV, I would recommend a carrier sheet, as the the clear "front" of the HTV tends to be very slippery. As for your second question, I would highly recommend checking out youtube. Videos should also show you which side of the HTV to be cutting. One of the most important things with HTV ... mirror your image and/or graphics! Share this post Link to post Share on other sites
mlgoodrich09 2 Posted April 30, 2021 8 minutes ago, haumana said: If you're trying to cut HTV, I would recommend a carrier sheet, as the the clear "front" of the HTV tends to be very slippery. As for your second question, I would highly recommend checking out youtube. Videos should also show you which side of the HTV to be cutting. One of the most important things with HTV ... mirror your image and/or graphics! ok thank you Share this post Link to post Share on other sites
darcshadow 1,627 Posted May 1, 2021 You load a sheet just like you would a roll. The cutter doesn't care how big of a piece of vinyl you're cutting. So long as the vinyl is big enough that the pinch rollers can grab it that's all you need. HTV can be slippery, but so far, I have not had any issues cutting small pieces on my MH. Share this post Link to post Share on other sites