someheartfeltgifts 0 Posted March 25, 2021 I have been using the Laserpoint 3 ARMS for about 3 years now but all I have done with it is cut vinyl. I now have a job that is taking deeper into into it and I am not sure where to go for help. I am using VinylMater DSR V4.3 and I am trying to cut door hangers. I have the everything set up with three door hangers on a page that is 8.5"h x 11"w. I can get it to cut just fine. But I cannot get it to line up in the same spot each time. Is there a way to create some sort of marks on the paper when I print and have the cutter scan for those marks so that it knows where to start the cutting at? Quote Share this post Link to post Share on other sites
darcshadow 1,627 Posted March 25, 2021 You're simply trying to do contour cutting. Google VM Contour cutting and you'll find several videos walking you through the process. 1 Quote Share this post Link to post Share on other sites
