Briguy 3 Posted August 25, 2019 Years ago I bought the memory upgrade for my MH cutter . Now, I am using a friends until I can get my Grsphtec . Looked to order the memory upgrade and US Cutter doesn't have them anymore . Anyone know I can get it ? Only found one other place and they are out of stock . Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 25, 2019 I have some new ones but there have been 3 different mainboards in the MH - make sure the one you have has room for the upgrade. Share this post Link to post Share on other sites
Briguy 3 Posted August 29, 2019 This is the original MH 721 , the current memory board is WS628128LLPG-70 . Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 29, 2019 that IC chip is a 28 pin the ones I have are 14 pin so no go here Share this post Link to post Share on other sites
Briguy 3 Posted August 29, 2019 Know anywhere I get get it ? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted August 29, 2019 Just now, Briguy said: Know anywhere I get get it ? Does it do the same thing, if you use the pen tool? If, not then more likely static. . Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 29, 2019 not a clue anymore - I think I ordered this from china 10 years ago and ordered several extra at the time - since going roland and graphtec never had to worry about it again. Share this post Link to post Share on other sites
Briguy 3 Posted August 29, 2019 I'm going to Graphtec as soon as I get the $ . Hopefully a month or so . Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 29, 2019 1 hour ago, Briguy said: I'm going to Graphtec as soon as I get the $ . Hopefully a month or so . you won't believe the difference - like the difference of driving a lawn tractor to town and a cadillac. you will be amazed 2 Share this post Link to post Share on other sites