MZ SKEETER 4,709 Posted August 26, 2019 Probably not the machine. If it is still cutting thru, then you have too much blade exposed out of the blade holder. Try a different cutting software and see what happens. Make sure that you haven't put scratches or gouges in your cutting strip. Share this post Link to post Share on other sites
raheel 0 Posted August 26, 2019 Yes I do notice guaged on the cutting strip. But only use 1 tint roll (around 30feet). Any precut software recommendation? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted August 26, 2019 If you were cutting thru the backing, then the blade was gouging the cutting strip. I only use Flexi software, with my cutter. I don't know anything about Tint software. Share this post Link to post Share on other sites