chris london 0 Posted December 19, 2017 have been using an old but faithfull graphtec fc2200-90 for nearly 20 years... untill recently when had to change a snapped drive belt then when we went to power up again.... there is no initialization routine...only the y bar moves very slowly down the table untill it get to the other end and stops no pressing of any buttons other than the power button can stop this motion has a sensor gone or something else.... would hate to bury this old faithfull just yet any thoughts ?? Share this post Link to post Share on other sites
MZ SKEETER 4,720 Posted December 19, 2017 Not sure how to factory reset that model. But other Graphtecs You hold down the UP arrow while turning on the power button. Have you tried that? Share this post Link to post Share on other sites
chris london 0 Posted December 19, 2017 yes tried the "hold UP arrow key ............... to no avail Share this post Link to post Share on other sites
MZ SKEETER 4,720 Posted December 19, 2017 have you tried Graphtec tech support? Share this post Link to post Share on other sites
