chris london

Members
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About chris london

  • Rank
    Newbie
  1. chris london

    graphtec fc2200-90

    yes tried the "hold UP arrow key ............... to no avail
  2. have been using an old but faithfull graphtec fc2200-90 for nearly 20 years... untill recently when had to change a snapped drive belt then when we went to power up again.... there is no initialization routine...only the y bar moves very slowly down the table untill it get to the other end and stops no pressing of any buttons other than the power button can stop this motion has a sensor gone or something else.... would hate to bury this old faithfull just yet any thoughts ??
  3. have been using an old but faithfull graphtec fc2200-90 for nearly 20 years... untill recently when had to change a snapped drive belt then when we went to power up again.... there is no initialization routine...only the y bar moves very slowly down the table untill it get to the other end and stops no pressing of any buttons other than the power button can stop this motion has a sensor gone or something else.... would hate to bury this old faithfull just yet any thoughts ??