Recommended Posts

have been using an old but faithfull graphtec fc2200-90 for nearly 20 years...

untill recently when had to change a snapped drive belt then when we went to power up again....

there is no initialization routine...only the y bar moves very slowly down the table untill it get to the other end and stops

no pressing of any buttons other than the power button can stop this motion

has a sensor gone or something else.... would hate to bury this old faithfull just yet 

any thoughts ??

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now