arty-rc 719 Posted January 24, 2017 After using my 14" mh on the road for a few years I've decided to take my 24" cutter instead. I used a rolling sport bag for the mh. I was thinking of getting a 36" rolling duffle bag that has a rigid bottom and extending metal handle for transporting it. Does anyone else have any other ideas for my venture? Thanks Share this post Link to post Share on other sites
Doliz 1 Posted January 24, 2017 Where do you travel to? Also I messaged you. Share this post Link to post Share on other sites
arty-rc 719 Posted January 24, 2017 Just need to transport it in my van a few times each year. Share this post Link to post Share on other sites
mfatty500 454 Posted January 24, 2017 I use this (only smaller) and travel with my graphtec every weekend, never an issue, I put it in a trailer with all of our other stuff, clothing, heat press etc. Share this post Link to post Share on other sites
mfatty500 454 Posted January 24, 2017 Oopps, Sorry Arty. Here you go. http://www.sterilite.com/SelectProduct.html?id=402&ProductCategory=182§ion=1 Share this post Link to post Share on other sites
cardudenc 151 Posted January 24, 2017 any of you do mobile decals? like at festivals and such. I'm thinking about setting things up in an enclosed vending trailer 1 Share this post Link to post Share on other sites
Primal Decals 621 Posted January 24, 2017 im in the process right now. Looking into a small enclosed trailer and another cutter so i can make things out on a job as well if needed, Share this post Link to post Share on other sites
arty-rc 719 Posted January 31, 2017 Update! I picked up a 36" rolling duffle bag at Wally World. It has a zippered lower compartment that I put five 24" x 10yd rolls of vinyl in and the Graphtec CE5000-60 in the upper compartment. All I need to do is install a support wall inside the lower compartment and a masonite platform for the cutter to sit on. Share this post Link to post Share on other sites
arty-rc 719 Posted February 4, 2017 The finished setup ready for the road. I still have room to put some short rolls of vinyl with the cutter. 3 Share this post Link to post Share on other sites
arty-rc 719 Posted February 10, 2017 Just finished making a portable vinyl roll/tape roll holder for use on the road. I had everything that I needed in my garage(wood, dowels, bearings and rubber pads). 1 Share this post Link to post Share on other sites