KimmieM 0 Posted October 25, 2015 My cutter froze up with less than 5% left to cut. Cutter shows Now is cutting, What do I do? Very new to this. Thanks Share this post Link to post Share on other sites
slice&dice 2,450 Posted October 25, 2015 You have to start again. 1 Share this post Link to post Share on other sites
KimmieM 0 Posted October 26, 2015 If I start again do I have to use another piece of vinyl or will it cut in same spot? I canceled that I One out. I made it larger, because it needed to be a little larger. It froze up half way though. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted October 26, 2015 you don't say which cutter, cutting program, how you connect to the plotter etc you are using - if a mh series sounds like a memory issue - some have gotten better results going with a serial connection Share this post Link to post Share on other sites
slice&dice 2,450 Posted October 26, 2015 Kimmie, you'll have to start cutting completely from scratch, there's no going back with vinyl that's been run through. Welcome to the Forum, by the way. Share this post Link to post Share on other sites