hawkkenz 0 Posted April 8, 2008 Just painted this cart and used paint mask cut on a pcut 24 for the graphics. The skull I pulled from on of the forums here.... Share this post Link to post Share on other sites
FatDad 2 Posted April 8, 2008 that looks awesome!!! Great job!! Share this post Link to post Share on other sites
imarcnut 0 Posted April 9, 2008 SSWWEeeeeeettt!!! skulls, flames n cross' these are a few of my favorite things......... Share this post Link to post Share on other sites
SmallSigns 23 Posted April 9, 2008 Just one word -- SWEET!!!! Share this post Link to post Share on other sites
cutme 5 Posted April 9, 2008 nice! i am wondering about the paint mask you are using. what is it, and where do you get it? bb Share this post Link to post Share on other sites
Topper 61 Posted April 12, 2008 Hey! That is my SKULL! hahaha, Should of told me you wanted to use it, I would of made you a better one. Looks good though. Share this post Link to post Share on other sites
hawkkenz 0 Posted April 12, 2008 I liked the skull just the way it was, I knew I had nabbed it fromthis forum... The paint mask I used was Avery, I bought it from an ebay seller, it's pretty cheap and seemed to work real well. Share this post Link to post Share on other sites
stealth 0 Posted April 12, 2008 lloks great, but being fairly new to this i dont know about 'paint mask' so do you just put it on and paint over it, then remove? Share this post Link to post Share on other sites
hawkkenz 0 Posted April 13, 2008 Yes, basically painted the whole things the pewter color, applied cut paint mask, taped off two tone area, then blew on the red color, let it flash and then pulled the paint mask off, then clearcoat. Share this post Link to post Share on other sites