blankey85 1 Posted February 23, 2014 I'm still fairly new at vinyl cutting. I'm trying to make a decal of a chainsaw bar/chain for my family. I'm trying to get the chain portion to become one line instead of many little pieces. I've been unable to figure out how to do this. Is there even a way and if so can you explain how it's done. Thanks in advance. I was going to upload the .eps file but it says that it's not allowed..... Share this post Link to post Share on other sites
slice&dice 2,450 Posted February 23, 2014 Node editing. Or welding. Share this post Link to post Share on other sites
blankey85 1 Posted February 23, 2014 I did try welding but thought it still showed multiple cutting direction arrows. I tried it again and it only shows one arrow. Thanks and sorry for such a dumb question apparently! Share this post Link to post Share on other sites