Chani 0 Posted March 20, 2008 Did a basic search and couldn't find my answer. VERY new to SignBlazer (only had it up and running for 45 minutes or so), and I'd like to know if it's possible for SignBlazer to read the media size directly from a Copam 2500, instead of needing to paste in the measurements off of the plotter itself. Thanks! Share this post Link to post Share on other sites
Chani 0 Posted March 20, 2008 Thanks. I didn't see a setting, so I thought not, but I wanted to make sure. Also, I should mention that this is SignBlazer Elements, not the full program. Thanks again! Share this post Link to post Share on other sites
kenimes 42 Posted March 20, 2008 SignBlazer and SignCut both will not take the measurment from the Copam cutter, but the cutter knows what size the material is and will not cut beyond what it has measured. You can also set the material size in each program manually. Share this post Link to post Share on other sites
Chani 0 Posted March 20, 2008 Thanks! That'll help prevent me from tearing my hair out looking for the button. Share this post Link to post Share on other sites