boggey090 1 Posted April 7, 2013 Is Signcut compatable with a Gerber Tempo 600? I've been trying to start cutting with the trial version but can't seem to find out what I doing wrong. Any advice? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 7, 2013 have you downloaded and installed the drivers? http://www.gspinc.com/default.asp?contentID=204#PLOTTERS Share this post Link to post Share on other sites
boggey090 1 Posted April 7, 2013 dakotagrafx, I have per the instructions furnished by Gerber. What I am going to try is uninstall and use your website to reinstall and see if that does the trick. I suspect there is no communicated between the computer and plotter. I'll keep adviced on how thing ops turns out. Thanks! Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 7, 2013 signcut would still need the drivers from gerber to communicate with the cutter - you have to install the usb drivers from gerber to make it work Share this post Link to post Share on other sites
boggey090 1 Posted April 7, 2013 Roger, Will do..... Share this post Link to post Share on other sites
