petroman2012 168 Posted February 9, 2013 My roller question is that when I am trial and error with this new machine LP II I am getting roller "dents" as it feeds the vinyl being cut, I can see the brass retainer nuts holding the retainer springs which give it the "fit" to feed as roller and roller grips move the vinyl, I had this issue with my R-31's and adjusted and adjusted till I had no more adjusment to adjust and have to live with it..Any suggestions on this trail of roller pressure and how to eliminate some or all with out going through adjusment fatique...Thanks... Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted February 10, 2013 Just try cutting a piece of vinyl,and make sure it has roller marks on it. Take the backing off the decal. and apply it to something. See if the roller marks go away. Most roller marks don't hurt anything, it is just part of the machine doing it's job. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 10, 2013 it is just a way of life witht he value cutters - the rollers are much more agressive but it doesn't show when applied like skeeter said Share this post Link to post Share on other sites