kevinscof 0 Posted February 8, 2013 Im new to this software. The issue is I have 2 images one overlaying the other to create my cut. The issue is it cuts threw both images following the edges of both. How can I stop it from cutting threw the middle of the overlaying image? Share this post Link to post Share on other sites
Ravenwind / One Off Grafx 187 Posted February 8, 2013 that sounds like a welding issue. post the file if you don't mind so people can get a better idea of what you mean. Share this post Link to post Share on other sites
kevinscof 0 Posted February 8, 2013 OK here it is.. if you notice where the mountain goes behind.. it cuts threw the rider the mountain outline.. Share this post Link to post Share on other sites
kevinscof 0 Posted February 8, 2013 It was the welding.. I figured out I had to weld both pieces.. thanks for the help Ravenwind Share this post Link to post Share on other sites
Ravenwind / One Off Grafx 187 Posted February 9, 2013 It was the welding.. I figured out I had to weld both pieces.. thanks for the help Ravenwind you are welcome Share this post Link to post Share on other sites