warthogworkwear 0 Posted December 1, 2012 Hey i purchased a MH721c cutter and i have signblazer / Inkscape / signblazer..all three i have something i need cut and my computer says it recognizes my uscutter but i cant getr it to cut or move, its like its just dead ! Can anyone help me figure out this problem !? thank you, Lucas 206-841-9986 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 1, 2012 Not enough info with that statement to even help you.. Best I got, is work your way thru here. Teaches how to setup. Plenty of info on this forum to read. I wouldn't wait for a phone call, if I was you...There is no tech support on here. Your the one who will need to make the phone call or email to UScutter on Monday, if you can't get it. http://start.uscutter.com/ Share this post Link to post Share on other sites
slice&dice 2,450 Posted December 2, 2012 Check your driver in the CUTTER / SETUP screen. It should be RedSail RS800c. Share this post Link to post Share on other sites