ruffhuff 2 Posted November 10, 2012 I'm test driving different versions of Flexi and I'm getting those inclomplete cuts in some of the finer details... on version 10 I fixed it by adjusting the blade offset and I can't seem to figure out how to do that on version 8.1... do they call it something different on this version or something? 1 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 10, 2012 It still should be blade offset.. You can also try Overcut to finish closing cuts. Share this post Link to post Share on other sites
ruffhuff 2 Posted November 11, 2012 I can't find anything that says offset... is that overcut the same thing? what number would I start that at? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 11, 2012 NO, overcut it not the same thing Share this post Link to post Share on other sites
carlytorres 1 Posted November 14, 2012 I friend I prepared this video , so here you can se how to changeblade offset. After trying many settings I found 0.17 is the setting that works for me. Share this post Link to post Share on other sites
Markk077 21 Posted November 15, 2012 You need to get in bed with your design software, your cutting software, your cutter, and any and all updates and driver changes. You MUST aqaint yourself with these. If not, all hope is lost. Just kidding, but you need to go back to the basics, seriouly. MarkK Share this post Link to post Share on other sites
ruffhuff 2 Posted November 18, 2012 that video helped... maybe I just accidentally stumbled across it on 10 or something and just couldn't remember how I did it... the over cut did work by the way... Don't really know the pros and cons of each yet... but I'm just starting out.. I had a little experience weeding and applying but this hardware/software relationship stuff is new to me... but thanks everyone for the help and input 1 Share this post Link to post Share on other sites