Megaworkz 3 Posted October 26, 2012 Went out to the shop today powered up the computer then the Pcut 630. LCD is blank or has a few boxes. However it still cuts fine any ideas what the problem is? 1 Share this post Link to post Share on other sites
BearlyRich 167 Posted October 26, 2012 No, sorry... But there used to be a special support topic on the USC web site (FAQ I think) that specifically metioned this problem. Although I think it had to do with the MH series, but may still be similar... Try a search either in the dorum or on the USC support site unless someone else chimes in with an answer. Share this post Link to post Share on other sites
mb20music 760 Posted October 26, 2012 a new replacement LCD screen is pretty cheap http://www.uscutter.com/Creation-LCD-Screen-CRPLCD Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 26, 2012 Yes, I read a bit fast, best to just call tech support, they probably know right away what it is. Share this post Link to post Share on other sites
mb20music 760 Posted October 26, 2012 LCD is blank or has a few boxes. However it still cuts fine Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 26, 2012 Yes in deed... Share this post Link to post Share on other sites
Megaworkz 3 Posted November 10, 2012 Yeah I've seen the FAQ. It doesn't apply to my problem. It's the kill switches on the sides to keep from damaging the motors. It does make to lcd go blank but also shuts the motors down. Mine still cuts I just can't see to make adjustments. I could deal with that if I didn't need to make pressure changes for T-Shirt vinyl. Share this post Link to post Share on other sites