Krookz 10 Posted October 4, 2012 Here's my first sand blast project. This is what pushed me to finally get a plotter and stop cutting stuff by hand and chemical etching. For my little brothers wedding. Yes... the letters are crooked on that one. Made doubles of each so no big deal 1 Share this post Link to post Share on other sites
arty-rc 719 Posted October 4, 2012 Looks good. You're hooked now!!!!! Share this post Link to post Share on other sites
Hummer 21 Posted October 4, 2012 Really nice work. What font did you use for the Mr. & Mrs.? Thank you... Share this post Link to post Share on other sites
Krookz 10 Posted October 4, 2012 Really nice work. What font did you use for the Mr. & Mrs.? Thank you... Used this font: http://www.dafont.com/billy-argel-font.font Rasterized, and chopped out the obvious logo and the piece attached to the M. I wanted the M and R joined Share this post Link to post Share on other sites
Hummer 21 Posted October 4, 2012 I figured out the font, but cannot get rid of the logo. How did you do this, please? Share this post Link to post Share on other sites
Krookz 10 Posted October 4, 2012 I figured out the font, but cannot get rid of the logo. How did you do this, please? Re-read what I wrote Share this post Link to post Share on other sites
Hummer 21 Posted October 4, 2012 I re-read what you wrote and looked up rasterized. I still don't understand... I tried a bunch of stuff in Corel Draw, among other programs that I have and I still cannot get rid of the logo. Thank you for your time anyways... Share this post Link to post Share on other sites
Hummer 21 Posted October 4, 2012 Yahoo! Figured it out...thank you Krookz... Share this post Link to post Share on other sites
Krookz 10 Posted October 5, 2012 Yahoo! Figured it out...thank you Krookz... Good job Share this post Link to post Share on other sites
