Seigea 0 Posted September 12, 2012 I work for a company that uses signblazer and a MH721 cutter. I made an .eps file on my laptopfor cutting, but couldn't hook it up to the older style cutter, so I used their computer, saved the image and tried to import it. The image doesn't come up as found. I saved it in illustrator too as an.ai but it still wont come up when I go to import. Is this a common problem? Share this post Link to post Share on other sites
mb20music 760 Posted September 12, 2012 When you tried to "import" did you try both of the options in the "import mode" box Share this post Link to post Share on other sites
Jay2703 704 Posted September 12, 2012 Open it in AI and save it as an older version 8 of .eps file. then it should import to SignBlazer. 1 Share this post Link to post Share on other sites
Seigea 0 Posted September 12, 2012 thanks for the help Share this post Link to post Share on other sites
Seigea 0 Posted September 12, 2012 Open it in AI and save it as an older version 8 of .eps file. then it should import to SignBlazer. how would i go about that? Share this post Link to post Share on other sites
Dr12volt1338 116 Posted September 12, 2012 how would i go about that? There is a drop down in the save as window that allows you to chose a few different versions of AI just make sure it is 8 or older. Share this post Link to post Share on other sites
