tweetlbug 0 Posted September 12, 2012 Three different files, two .ai and one .jpg and used Flexi to vectorize. Getting the same result regardless of file. Scale in Flexi shows 5 inches wide, but the MH721 cuts it as 3 inches wide. The proportions are still correct, it's just smaller by 40% each time. It's consistent with the proportions always being off by 40%. Its not confusing inches for CM, which was my first thought. using Serial connection with a physical card in my computer, not a keyspanner. it has worked correctly in the past. Win 7 64 bit 8 gigs of ram MH721 its grounded, I even used fabric softener sheet on the vinyl before cutting. "Job Size" shows 100% as well Share this post Link to post Share on other sites