kelliann 4 Posted March 13, 2012 I tried something new. Well, new to me. It worked really quite well, so I thought I'd share. I was looking for a really great way to hem the edges on a banner that would be outside in the wind, snow, rain, and cold weather. (I purchased a large blank roll, and was hoping to save some money doing it that way.) I tried using hem tape...no luck, just didn't stick well enough. I tried using my sewing machine to hem the egdes...no luck, just kept breaking the thread (I shall try it again another time though). So I tried using some PVC glue. (A 2-part glue. I painted one edge with part 1 and the other side of the fold with part 2. Then I pressed them together). First, I tried it on a few practice pieces, soaked them in water and froze them. Once they were good and frozen, we grabbed the ends with pliers and pulled as hard as we could. The banner didn't tear. I also was able to punch a grommet through the layers. It seemed to seal the layers together nicely. *As a note, the PVC glue is a bit messy. So be careful where it touches. It melts/bonds the layers together, and it leaves the hemmed edge lumpy in places. I think with practice I can solve that issue. Share this post Link to post Share on other sites
daron 10 Posted March 22, 2012 thanks I'm looking into making a few banners and yes its cheaper to make ya own good way to seem it up Share this post Link to post Share on other sites