mmilam90 0 Posted February 22, 2012 Just recieved my MH series 14 inch plotter. I've watched the videos and read reviews before buying. One thing I noticed was that everyone always made sure to use the ground wire with the stand. There is no option for a stand with the 14 inch. Do I still need to ground it to something? Maybe look for a table to make it a permanent fixture there? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted February 22, 2012 You might not have to ground it at all. I've had 7 different cutters over the years and never had to ground any of them,and never had any problems.Try it out and see before you worry about it. Share this post Link to post Share on other sites
arty-rc 719 Posted February 22, 2012 I've been using my 365 for 2 years without grounding it and have had no problems. Share this post Link to post Share on other sites
slice&dice 2,451 Posted February 22, 2012 I grounded mine, I hope this was the right way to do it? 1 Share this post Link to post Share on other sites
BannerJohn 1,324 Posted February 22, 2012 I grounded mine, I hope this was the right way to do it? yeah but only in Texas.Anywhere else it would get wet. Share this post Link to post Share on other sites
mmilam90 0 Posted February 22, 2012 Thanks for the info! I'll try throwing it outside and seeing if those does any good. Share this post Link to post Share on other sites