BACK2 0 Posted September 26, 2011 How do I get text to cure on an arch, I can not seem figure it out. Share this post Link to post Share on other sites
mfatty500 454 Posted September 26, 2011 How do I get text to cure on an arch, I can not seem figure it out. What software are you using? Share this post Link to post Share on other sites
paulzeee 1 Posted November 8, 2011 Being this is the Inkscape forum - you can probably assume Inkscape? One way to do it is to create the arc you want using bezier tool. Type your text. Select the text and arc you created then go up to "Text" option at top of the page then choose "put on path". Share this post Link to post Share on other sites
stickeysand 13 Posted November 18, 2011 Oh thank you for that very simple explanation. I use SB f Share this post Link to post Share on other sites
stickeysand 13 Posted November 18, 2011 ( stupid smartphone I wasn't done typing) SB for my text creations however can never get them to Open in sign cut so they do me no good now I'm redoing all my work over again. But in Inkscape, which is simpler to learn but dang wish there was a simple easy read manuel on it. Thank you for the simplicity of your answer. Share this post Link to post Share on other sites