livingagain75 0 Posted July 18, 2011 Hi guys and gals, I was wondering where would me my best option to upgrade to. I have an LP 24" Corel 4, Adobe CS5 Design Suite, a PC, and wouldn't mind cutting straight outta the design software. Any suggestions? P.S. I am not a gazillionarre... Thanks, Bill Share this post Link to post Share on other sites
Rodger 527 Posted July 18, 2011 That is why I went & stayed with SB . It makes anything I want , so good for me . I mostly letter trucks & it does a SWELL job . InkScape is great also , but you have to send it to a cutting software . Flexi Starter is a joke compared to SB IMO . I bought it & wished I hadn't . Share this post Link to post Share on other sites
AshComputers 197 Posted July 18, 2011 Signcut is the best cutting software I've used, and then there's Flexi 10, not starter either That only my opionion though, others may vary Share this post Link to post Share on other sites
livingagain75 0 Posted July 19, 2011 Thanks for the replies, ya SB has been good to me. My only problem is the frequent stops midcut. Hopefully that will stop soon, I finally ordered a DB-9 adapter. I have another problem but I will start a new thread. I actually bought my LP used so I didn't get the 1 year signcut trial. How much is the license? Share this post Link to post Share on other sites
Rodger 527 Posted July 19, 2011 I had a few quirks before I went to serial cable , no problems since then Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted July 19, 2011 I went serial right out of the box and never a glitch(other than my own stupidity) Dan Share this post Link to post Share on other sites