prototype66 20 Posted June 13, 2011 I did my version of the Grand Ledge design. White base is 3M Scotchcal Blue is General Formulations 5000 series Yellow is MacTac (I love this stuff!) Thank you reg marks for working on this the 3rd try! lol Got it down now after a bit of Pressure adjustments and node fine tuning. Share this post Link to post Share on other sites
vinylmotivations 143 Posted June 13, 2011 I did my version of the Grand Ledge design. White base is 3M Scotchcal Blue is General Formulations 5000 series Yellow is MacTac (I love this stuff!) Thank you reg marks for working on this the 3rd try! lol Got it down now after a bit of Pressure adjustments and node fine tuning. I have been using the MacTac Aqueous and overlam.... seems like they make a good product and I may be willing to try their other products. They make some stuff that is pretty compareable to the Oracal 631 that I am going to give a shot to. Share this post Link to post Share on other sites
prototype66 20 Posted June 13, 2011 This is supposed to be the equivalent of 651 so I am happy with it. Share this post Link to post Share on other sites
tekcorps 50 Posted June 13, 2011 Was the 3M HP vinyl? What did you think about cutting the 3M? Share this post Link to post Share on other sites
prototype66 20 Posted June 13, 2011 well it has a clear backing which is nice for release and it cuts ok but it seems to get lifted in my cutter if it is a fine detail type of design. It is very soft and a bit thin. Real small pieces end up on the carriage. Other than that it's a nice producr. I use it exclusively for base cuts ( under hard to see colors) now or simple cuts and font. Share this post Link to post Share on other sites
