xpfguy 39 Posted May 19, 2011 This is partially cleaned up. I started with a scan off a scrap paper where my customer drew this. I am still learning illy so tips on how to make it cuttable appreciated. note: I need advice on how to save files... They are always too big. what settings and file type should i be using? Share this post Link to post Share on other sites
xpfguy 39 Posted May 19, 2011 .ai version flr scan.ai Share this post Link to post Share on other sites
tekcorps 50 Posted May 19, 2011 Might try doing some image editing and clean up in Photoshop before tracing. Share this post Link to post Share on other sites
prototype66 20 Posted May 19, 2011 or maybe make a few layers.. put sketch in first layer at 25% transparency draw the lines and adjust nodes to match in the other layers smart fill and clean up your images in the other layers ditch the sketch Share this post Link to post Share on other sites
mark-s 1,126 Posted May 19, 2011 The best way is what tekcorps said. mark-s Share this post Link to post Share on other sites
xpfguy 39 Posted May 19, 2011 Thanks everyone, I'll give both ideas a try and see what happens. Jason Share this post Link to post Share on other sites