Si 0 Posted January 6, 2008 I am running Win XP Service Pack 2 FlexiSIGN Pro 7.6v2 "Refine EH 721" using the PNC-1000 config connected via serial cable getting write port error always software will not run machine, it was running once upon a time with the exact same setup just FlexiSIGN Pro 7.0 then. is there any resolution for this yet? cheers Sai, Share this post Link to post Share on other sites
Beardown 0 Posted January 6, 2008 I had this and I had to change the buad rate to 4800 in the software and on the cutter itself Share this post Link to post Share on other sites
Si 0 Posted January 7, 2008 nope no joy, it didn't work at all. got any other suggestions i can try. :why: Share this post Link to post Share on other sites
kenimes 42 Posted January 7, 2008 Maybe try setting the COM1 port Flow Control to hardware in the device manager. Share this post Link to post Share on other sites
