laserman70 2 Posted January 2, 2008 Ok say i have a flame like the one below, i want just an outline of it say a 1/8 inch thick and want nothing in the middle so when it cuts it is just the outline 1/8 inch. So i can weed it out and just see the outline. Hope that makes sence lol thanks Gregg EZF001.EPS EZF001.EPS Share this post Link to post Share on other sites
laserman70 2 Posted January 2, 2008 lol never mind, ummm outline duh. Share this post Link to post Share on other sites
Guest Terry Posted January 2, 2008 yup, I place a stroke then go to path create outline, I think thats how I do it. Share this post Link to post Share on other sites
Jerry Bonham 1 Posted January 2, 2008 Here it is for you done in two seconds in SignBlazer. Enjoy Jerry from SignBlazer. flame 2.EPS flame 2.EPS Share this post Link to post Share on other sites
