freebird1963 11 Posted October 1, 2010 Has anyone tried cutting Imprintable Warehouse SPECTRA FOIL ? I have a MH-721 with CLEAN CUT BLADES and can not seem to do more than scratch it. I was at 420 force too ! Yea I am cutting on the right side of the vinly too. I can feel the lines but doesn't weed at all. I can't see any lines either. I put the crappy BGS vinly back on to make sure there wasn't any issues with the cutter and cut right thru it cuz I forgot to change the force. Thanks Mark Share this post Link to post Share on other sites
roxanneupnorth 106 Posted October 1, 2010 Can't help with a MH721 but I use an Expert 24 and cut at 130 with 45 blade and do not have any problems....You should not need as much pressure as you are using..... Share this post Link to post Share on other sites
freebird1963 11 Posted October 1, 2010 Thanks. thats what I think but can't get it cut. How do you like the GCC Expert 24 ? It doesn't have contour cutting ability does it ? I think I am gonna start looking for a new cutter. Thanks Mark Share this post Link to post Share on other sites
roxanneupnorth 106 Posted October 1, 2010 I like the Expert 24.....The new Expert 24 LX will have contour cutting.....It will be out soon..... Zencut Green is made by GCC so it is worth a look.....Not sure if you can get and/or use the Great Cut software with it.... Share this post Link to post Share on other sites
rackitup 0 Posted October 2, 2010 I am not familliar with that material, however I have recently been experimenting with thicker vinyls of different hardnesses I am using a 60 blade, http://www.uscutter.com/3-Pack-of-Roland-Cemented-Carbide-Blades--60-Degrees-_p_146.html I noticed US Cutter has a blade for tinting vinyl, http://www.uscutter.com/-USCutterMyTinter-Blade-Set-Pkg-of-5-_p_1316.html greg Share this post Link to post Share on other sites
freebird1963 11 Posted October 2, 2010 Hey Rox Does the GCC close cut paths good. That is one complaint i have with this dang mh 721 is it seems to not close cuts very well. Is it good at cutting good detail and small letters ? Thanks Mark Share this post Link to post Share on other sites