ajgarber70 0 Posted September 7, 2010 Just asking before i buy some of this high dollar stuff i was wanting to know since it is thick. I have the us cutter laserpoint and if so if anyone can tell me where they set the speed and pressure settings and what kind of masking tape would work good with this stuff looking at the oracal 5600 series thank's. SORRY IF THIS IS A DUMB QUESTION Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted September 8, 2010 I don't know about cutting the reflective with the lazerpoint ( I have a p cut ) the pressure and speed is in the set up menu after it powers up just press the offline button and scroll thru the settings on the screen. If you don't have a manual you can download one at us cutters website. I have cut reflective with my p cut and as i understand the lazerpoint is about the same. The 5600 is 5 mill thick that is 2 mill thicker than 651 so after adjusting the pressure it should cut fine be sure to do practice cuts before starting the cutting. You will need to adjust your blade height and cutting pressure. the reflective will do your blade in fairly quickly Dan Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted September 8, 2010 Laser point is a creation P-cut with a manual alignment laser on it - same machine Share this post Link to post Share on other sites
ajgarber70 0 Posted September 8, 2010 Thank you for the info Share this post Link to post Share on other sites