xpfguy 39 Posted August 4, 2010 I have a file I'm trying to cut and the name which is in script and arcs above the other text does not show up when I send the file to CM2 for cutting? also why are the text or picture "frames" (just the area that frames the text box even when not outlined) sometimes cut with they should not be? does that make sense? Jason Share this post Link to post Share on other sites
mark-s 1,126 Posted August 4, 2010 What font ? mark-s Share this post Link to post Share on other sites
xpfguy 39 Posted August 4, 2010 brush script std med Share this post Link to post Share on other sites
mark-s 1,126 Posted August 4, 2010 Odd I had no trouble with it. Did u weld them? mark-s Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted August 4, 2010 If you go into the ADVANCED tab at the top in Cutting Master, ... it has auto weld , half way down on mine. < on my advanced tab it looks like a blade that could be what he is referring to. Share this post Link to post Share on other sites
xpfguy 39 Posted August 4, 2010 ok, does that stop it from cutting the edges of the text and image boxes? I still can't get the "Anthony's" to show up when I send to CM2 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted August 4, 2010 NO. and I don't know what you mean, sounds like your workspace isn't big enough or something if it''s cutting it. I don't use the Cutting Master. I just have it. I use Flexistarter8.6 much easier. You can import many different file formats with Flexistarter, not just send them from Illy, you have not posted the .ai file After looking at your signiture, I can't import CS4, too new Share this post Link to post Share on other sites
xpfguy 39 Posted August 5, 2010 Thanks, I figured it out and don't know how . I just deleted the text, retyped it and warped it.... presto.. thanks again... and now I'm on CS5, need to update my signature. Share this post Link to post Share on other sites
jeremySI 18 Posted August 5, 2010 i am guessing you either had it out of the workspace area or it was a different color than the rest of your design and you had it set up to only cut a single color, so that one wasnt showing up. jax fl huh i am up in st marys ga. always going to jax. Share this post Link to post Share on other sites
xpfguy 39 Posted August 5, 2010 Thanks for all the help guys. Cutting the reflective material for first time was a little odd. weeding was hard because it would rip easy. thanks again jason Share this post Link to post Share on other sites