ericnord 0 Posted June 13, 2010 Hey everyone, I have a Copam cutter that I'm starting to learn how to use. It is cutting nicely, but I cannot get my vinyl pieces transferred to the object I wish to mask. I have Oramask 810 for vinyl, and R-Tape AT-41 transfer tape. The vinyl just sticks to the transfer tape and will not let go... Thanks for any help Share this post Link to post Share on other sites
mars 45 Posted June 14, 2010 If the AT-41 is too strong - go with a lower tack transfer tape - or a different vinyl (stronger adhesive on vinyl) If it is just hard to work with it I have had luck by pulling the transfer tape back over itself - 180 degrees and letting the fingers of my other hand ride along the fold back line of the app tape - pressing down with a little friction in the direction I am pulling the app tape - -careful to watch that the vinyl is staying down - it is a pain in the butt. -Mike Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted June 14, 2010 QUESTION: What type of application tape should you use with ProGrade Share this post Link to post Share on other sites
lynnpromotions 0 Posted June 14, 2010 Make sure you are removing the paper backing on the vinyl too. Share this post Link to post Share on other sites