Jason50 1 Posted May 11, 2010 I have two copam cutters. My older one leaves the cut graphic handing out of the front of the machine (which is great). My new machine returns to the original point. I figure there must be a setting to change the origin point, but for the live of me I cannot find it. Your help is appreciated. Thanks Jason Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 11, 2010 If your using Sign Blazer, In set up, there is advance page after job. Is that what you are referring to? Share this post Link to post Share on other sites
Jason50 1 Posted May 11, 2010 yes, that is what i am referring to, but i am not currently using sign blazer. i use the generic "letters cutter" driver. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 11, 2010 generic "letters cutter" driver? I am not familiar with that. What is that? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 11, 2010 generic "letters cutter" driver? I am not familiar with that. What is that? I'm curious also Share this post Link to post Share on other sites