Killo 0 Posted April 28, 2010 I've had my cutter for about 2 years. I haven't used it for more than a year now. I tried to use it tonight and program can't communicate with the cutter. I get an error message that say it can't initialize the cutter. Any ideas or suggestions? Share this post Link to post Share on other sites
CRD 9 Posted April 30, 2010 The link to solve your problem. http://forum.uscutter.com/index.php/topic,17489.0.html Paco Share this post Link to post Share on other sites
Killo 0 Posted April 30, 2010 Thanks for that info. That's certainly a more complete instructional than the manufacturer supplies. I had to run the "repair/modify" for SBE. The setup icons were not present for some reason. Once I could get to the setup, it only allows up to COM9 and mine was in COM19. I changed to a different COM port (which turned out to be COM8), set that in SBE and I was off and running again. Again, thanks for the help. I truly appreciate it. Share this post Link to post Share on other sites
CRD 9 Posted May 1, 2010 That is why this forum is for. Keep you going........ Paco Share this post Link to post Share on other sites
