mr_signs 0 Posted April 15, 2010 Hello Everyone, Hoping someone on here can help me out... Signcut makes 2-3 passes over the same cut even though I have it set to only make 1 pass. Not sure what i am doing wrong if anything. I was able to reduce the number of nodes the vectorized image had so I don't think thats the problem. Any help would be appreciated! Here's my setup: Macbook OSx 10.5.8 Signcut Pro w/Mac Build 1.07 AI CS4 Maybe the trace option in AI is causing this? I just need it to stop after the first pass and move on to the next, you know...lol! Thanks! Share this post Link to post Share on other sites
tinaski 11 Posted April 15, 2010 sounds like there is more than one image on top it happens - ungroup it then drag apart - you prob will find there is more than one cutting line on top of each other Share this post Link to post Share on other sites
TSQUIRTZ 0 Posted April 15, 2010 Right on! +1 Remember the first time that happened to me, took forever and a lot of vinyl to figure that out. But I didn't know about this forum then either Share this post Link to post Share on other sites
mr_signs 0 Posted April 17, 2010 sounds like there is more than one image on top it happens - ungroup it then drag apart - you prob will find there is more than one cutting line on top of each other Awesome I will try that out!! That would do it. I'll post how that goes tomorrow... Thanks again! Share this post Link to post Share on other sites