Scotty 0 Posted April 13, 2010 i was just curious if there are any cheap vinyl plotters that could cut automotive gasket paper? thanks. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 13, 2010 I think gaskets are die cut and not cutable with a vinyl cutter - it would be too thick I would think Share this post Link to post Share on other sites
cohort 0 Posted April 14, 2010 The KNK cutter claims it can do up to 1/8" thick materials up to balsa density. Share this post Link to post Share on other sites
tlzimmerman 11 Posted April 20, 2010 If anything would I would say it would be the GCC Jaguar IV (Or Zencut black...same machine) They seem to have the most downforce of anything I have looked at (600G). For comparison Most vinyl is cut at 100g or below. Many sign programs like flexi you can set it to run multiple passes on the cuts, so even if it didn't cut through the first time, you could get a real good score on it to pop it out. My refine will cut cardstock just fine, and I know gasket is multiple times thicker than cardstock but I would be interested to see if it would work. Might be hard on the cutter though, and you would go through blades pretty quick I would bet. Share this post Link to post Share on other sites