rock jeep 1 Posted March 4, 2010 Help! Our Signblazer has decided today that it won't cut anymore. The message that pops up reads: "Cannot open the output device. Error initializing cutter." We have not done anything out of the norm, so we don't know how it happened. We checked to make sure the device had not come unplugged, but it all looks good to go. Anyone know what to do? Also, just recently, when we go to sign in to Signblazer and click trial mode like we always have, it gives a timer that never used to be there. When it first started doing this, it was about a 3-5 second wait before it would open, now it's up to 43 seconds before it will open up! We also have no idea how this occurred. If anyone can help explain our 2 problems, please do so! Thanks! Share this post Link to post Share on other sites
deth502 39 Posted March 4, 2010 i have no idea about the timer, but afa the cutter issue, make sure its set to the correct port in the setup menu. Share this post Link to post Share on other sites
jcart 11 Posted March 4, 2010 I have that problem every now and then too it seems to change ports on it's own. Change back and it should work fine. Share this post Link to post Share on other sites
rock jeep 1 Posted March 4, 2010 Yeah, it had to have done it on it's own, but we will look into that. Thanks to both of you... Share this post Link to post Share on other sites
rock jeep 1 Posted March 4, 2010 Ok, we got it! Thanks again! But if anyone can still figure out my problem with signing in to Signblazer, please let me know! Thanks! Share this post Link to post Share on other sites
Jay2703 704 Posted March 4, 2010 There are a couple of patches on the signblazer forum that will get rid of the counter. Share this post Link to post Share on other sites