Paintslinger 0 Posted November 23, 2007 When you cut something the cutter always goes back to where it started.Is there any way to get it to get ready for a new cut or do you always have to run it up manual. Thanks Share this post Link to post Share on other sites
BannerJohn 1,324 Posted November 23, 2007 I've never been able to do this in Signcut. Signblazer will let you do it. BUT it goes back to start after you being your next cut so you have to reset after each cut. I was told that the problem isn't in the software,but in the cutter's ability to recognize the commands. Share this post Link to post Share on other sites
Kimon 1 Posted November 24, 2007 We are happy to assist you with your question but first we need to know what plotter you are using. Share this post Link to post Share on other sites
Paintslinger 0 Posted November 25, 2007 mh 721 refine. Share this post Link to post Share on other sites
Kimon 1 Posted December 1, 2007 Sorry been down with the flu for a few days, we have just updated the machine files in signcut 2.19 please download the most recent version. I think you will find your problem resolved. Share this post Link to post Share on other sites