etchworks 0 Posted December 10, 2009 I have a 48" laserpoint and I never actually calibrated the x and y axis. Just thought it would work properly out of the box. Well I noticed some stuff is not the same size as others. so I tried to calibrate the cutter the x axis seems to be fine but the y axis is too big by 1/8 of an inch in 5 inches and as the object gets bigger so does the increase in the y axis cut. I have tried to reset the y but everything I do seems to do nothing I have tried to lower the y axis number and I still get the 1/8 inch too big. I am back to the default of 25858 for the Y and 25795 for the X. Anyone have any ideas?? I'm using Flexi on an XP machine. I also tried the cut in signblazer and I'm getting the same problem. Any help is appreciated. Dave Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 10, 2009 what is your resolution number in the job defaults? Share this post Link to post Share on other sites
etchworks 0 Posted December 10, 2009 Car, it's 1016. Why does that make a differance?? Dave Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 10, 2009 Just checking, it is the steps,, just making sure it was where it should be. Share this post Link to post Share on other sites
etchworks 0 Posted December 10, 2009 Thanks. Very frustrating !! Share this post Link to post Share on other sites
