PCUT630 Cuts half of the decal then goes to left and hits red button

[RocketRollinSX 2]

I am trying to cut a 23.25" wide decal on 24" vinyl.  I set the start point way to the right side like I always do and zero it out.  I hit cut and it starts to cut and all is well.  About halfway through the cutter moves to the top of the design and cuts a line across the top, off the edge till it runs into the red button.  I have my roll size set to 24" and the design down to 23" and it still does it.  Any ideas?

[mr300s 1,272]

This is just a guess try taking off the weed border and see if that helps

[Dakotagrafx 7,297]

What software and what do you have the material size set at in the cutting portion of your software

[CRD 9]

Try a imple 23 " witdh square which only has four nodes and see if this works.

Paco