racefab11 0 Posted December 8, 2009 I have up installed win 7 on a xp machine which works fine . I have a roland pc600 that i have used with xp and flexi 8.1 with no problems. When i set printer up in flexi i can run test cut and test print with no problems. When i send a contour cut/print to the machine, it shows generating job file then "caught exception, error code -6". the production manager shows processing , but nothing ever happens. I went into preferences and unchecked the tcp/ip setting in rip and print with no luck. I have tryed every setting in port configurations with no luck, any ideas? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 8, 2009 did you do a fresh install or just an upgrade? Go for the fresh install. was advised in this thread http://forum.uscutter.com/index.php/topic,22857.0.html Share this post Link to post Share on other sites
racefab11 0 Posted December 8, 2009 I did the upgrade with the custom option which is the fresh install. Share this post Link to post Share on other sites
racefab11 0 Posted December 8, 2009 It is 32 bit also. Share this post Link to post Share on other sites
racefab11 0 Posted December 8, 2009 This problem only happens when u print and rip. I can send a cut file and it will cut , or send a print file will print but not both. Share this post Link to post Share on other sites