fragged8 0 Posted December 7, 2009 hiya i've updated to the latest version of signcut because when cutting the plotter works fine until i dial in blade offset. as soon as I put in blade offset the same graphic goes wild as if im cutting hundreds of nodes ?? the same thing is happening with the new version ? any ideas anyone ? regards Richard details below Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 20, 2009 what number are you using for blade offset? As I do believe Signcut offset is in inches not mm ... or does it have both choices, inches and mm? you have not gotten it to run since 12/6?, Did you contact Signcut at their website? Share this post Link to post Share on other sites