CREATIVEDESIGN 0 Posted November 9, 2007 I JUST GOT A CUTTER CREATION 24" WHEN I CUT A LARGE GROUP OF SMALL SIGNS IT DOES NOT CUT AFTER 15 SECONDS AND ALSO I CANNOT LINE UP TAPE TO GET TO CUT CORRECTLY AND COST EFFECTIVELY ONE ON TOP OF THE OTHER WENT THROUGH A WHOLE ROLL AND I AM READY TO BREAK MY CUTTER Share this post Link to post Share on other sites
Guest fivestar Posted November 9, 2007 I JUST GOT A CUTTER CREATION 24" WHEN I CUT A LARGE GROUP OF SMALL SIGNS IT DOES NOT CUT AFTER 15 SECONDS AND ALSO I CANNOT LINE UP TAPE TO GET TO CUT CORRECTLY AND COST EFFECTIVELY ONE ON TOP OF THE OTHER WENT THROUGH A WHOLE ROLL AND I AM READY TO BREAK MY CUTTER What exactly happens after 15 seconds and the rest of your post I am lost on. I don't know exactly what you're trying to say. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted November 9, 2007 If you are saying it stops cutting,I think it might be a memory issue. Try cutting a smaller amount of the signs at once. This should also help with the vinyl drift. Share this post Link to post Share on other sites
kenimes 42 Posted November 9, 2007 I have also heard that when the cutter stops part way through a cut job, that it could be the USB cable. Some have replaced the cable and got better results. Share this post Link to post Share on other sites