abnvan 0 Posted February 16, 2007 We just purchased a us cutter 50" but.. we want to know how to have it stop after cutting instead of going back to the starting point. There is an option in Flexi and we have it check but it does not work... help is there a setting for this? Share this post Link to post Share on other sites
TaterNuts 3 Posted February 17, 2007 I have the same problem, I check and uncheck the box in the design editor and it doesnt matter, very very nerve racking, if anyone has a fix for this please let us know. I am not using a 50 inch machine, but a 25 inch machine Share this post Link to post Share on other sites
Beardown 0 Posted February 17, 2007 Is this just because you do not want it to go back to the starting point so that you do not have to roll back through all the vinyl that you kust cut? Share this post Link to post Share on other sites
TaterNuts 3 Posted February 17, 2007 Exactly, Everytime i cut anything with flexi, it does not advance the vinyl after the plot. it always goes back to the origin or starting point. Its kind of annoying, but workable. Ive never had a machine that does it. When I cut with WinPCSign, It does advance the vinyl after plot, but I have to reset the machine before i make another cut because it will try to start at the previous origin... Once again, annoying, but workable. But Flexi will not advance the plot at all... Any Suggestions? Share this post Link to post Share on other sites