hamnermitch 0 Posted September 18, 2009 I recently purchased a new refine mh721 and as many of you have had to do, I am learning how to use it with no help from instructions, as it basically came with none! My problem is that I can make a test cut by using the test button on the cutter, but when I use signblazer to try and cut anything, it says that it is communicating with the cutter but never ever does anything. What am I doing wrong? Can anyone offer any help? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted September 18, 2009 how are you connected? USB or Serial? What are your settings in SignBlazer? Com Port? Baud rate? Chosen cutter? etc. Share this post Link to post Share on other sites