reelguitars 0 Posted August 9, 2009 I just bought a used Encad Novacut 54. Can I make it work with SignBlazer? Share this post Link to post Share on other sites
lueman 19 Posted August 9, 2009 you probably need the right driver, I tried installing an hpgl driver for my LP24 ( I wanted to run it directly from corel) but I haven't found any that worked. Share this post Link to post Share on other sites
MZ SKEETER 4,710 Posted August 9, 2009 I just bought a used Encad Novacut 54. Can I make it work with SignBlazer? maybe you can get some help here http://www.asigns.com/signtools/Support/Encad/NovaCut%2054.htm Share this post Link to post Share on other sites
MZ SKEETER 4,710 Posted August 9, 2009 you probably need the right driver, I tried installing an hpgl driver for my LP24 ( I wanted to run it directly from corel) but I haven't found any that worked. this site has alot of drivers for different cutters for corel, , maybe you too can find one.. http://www.asigns.com/signtools_cutters.htm Share this post Link to post Share on other sites