MikeMan 0 Posted August 8, 2009 Just got this installed tonight - picked up off eBay for $129.50 with dongle. Not loving the splash screens that go on for long while when starting program, and again when production manager launches, but I'm definitely looking forward to playing with this tomorrow. My 2 main interests are the plot fill feature, and the ability to contour cut larger stuff than I can with SignBlazer. This version has drivers for all(?) the US Cutter machines. Screen shot attached Share this post Link to post Share on other sites
Sandstormdesigns 2 Posted September 9, 2009 I just purchased this version also. I was hoping that it would have my plotter on there with the correct driver. I have the new Graphtec FC8000 series. It seems as if all other cutting software except Cutting Master 2 uses the HPGL language for the FC7000 series instead of the GPGL. I wanted to see how well and the difference is the FlexiStarter 8.6v Contour Cutting than the FlexiStarter 8.6v without Contour Cutting. Share this post Link to post Share on other sites