lenmcc 0 Posted July 17, 2009 Argh. My hard drive died, and now that my Mac is repaired, I'm struggling to get everything back to the way I had it. Despite following the setup instructions, Signcut isn't communicating with my plotter. Computer: MacBook Pro, intel, running OS X.5; Plotter: PCut CTN630; Connection: Keyspan adapter; SignCut setup ("cutter" screen): Cutter: Refine MH721 (I think this is how I had it set up before. If this is wrong, I couldn't figure out how to install the CTN630 driver); Device: /dev/cu...; Baud: 9600. Share this post Link to post Share on other sites